MAXCOVER is an angular trapezoidal box profile suitable for both for roofing and wall cladding. It is particularly widely used in domestic and light industrial/commercial roofing applications. This product couples great looks with the widest cover width, making it a very economical alternative to many other profiles.
|Base Material||Pre-Painted Aluminium Zinc coated steel|
|Overall cover width – mm||1075|
|Effective cover width – mm||1015|
|No. of troughs||5|
|Pitch – mm||203|
|Available Thickness||28G (0.30 mm), 26G (0.40 mm) & 24G (0.50 mm)|
Recommended minimum timber cross-sectional size are :
Purlins - 75 X 50mm, Trusses - 100 X 50mm.
Maximum Purlin Spacing
0.30mm thickness material :- 800mm.
0.40mm thickness and above :- 900mm to 1mtr.
Note :-It is recommended to use single lengths to cover each run of roof from crest to eave and avoid end lapping for better aesthetics and economy.
When using MaxCover sheeting the recommended minimum pitch for roof sheets in excess of 15m is 7.5 Degrees and for sheets less than 15m is 5 Degrees.
70mm self-drilling timber screws or twisted shank roofing nails are to be fixed through the crest of the profile ribs using an electric screw guns (drill) or by hammering through pre-drilled holes. 65mm self-drilling screws to be used on steel purlins. Either fastener must be used in conjunction with appropriate uPVC washers.
Note:- MaxCover are fixed by drilling fasteners through its crest its recommended to use minimum 3 fasteners across each width of the profile (both ends at the overlap and center).
* The Actual Color of the product may vary from the one shown above.